It is currently Thu Nov 26, 2020 3:39 pm




Post new topic Reply to topic  [ 1 post ] 
 Clone Tech updates 
Vice President

Joined: Sat Feb 28, 2009 11:19 pm
Posts: 539
Location: Columbus, Ohio
Class: Jr. Clone
Chassis: Bandit
Engine: 4 cycle Clone
Post Clone Tech updates
This was posted by Bill McCutchen AKRA.


Join Date: 06 05
Location: Monroe, NC
Posts: 980
AKRA Tech Updates 2012
AKRA 2012 Tech Updates
Effective 2/20/2012
(Changes In Blue)

Page 48: Block Requirements: Stock cylinder bore is 2.685” max. Stroke is 2.123” + .010” or - .010”.

Page 48: Valve Train: Stock valve cover only with any stock configuration gasket, no sealer. Factory stock rocker arms 1:1 ratio and push rods only. Stock valves only 45 degree angle only
both valves, Intake valve Max OD .982” +/- .005” and Exhaust valve Max OD .945” +/- .005”,
no modifications allowed.

Page 49: Minimum thickness of Intake retainer .227”, Exhaust retainer .250”. BS lifters only, no modifications allowed.


Effective 5/1/2012

Page 48-49: Valve Train: Add ( Additional check for valve springs – Each spring is to be checked using a .750”height by .800”width plate gauge and a .250” (square) no-go gauge to check the center spacing of the spring coils while inserted in the plate gauge.) Prescribed check procedure as follows – Insert the spring in the .750” X .800” plate gauge (spring must be centered in plate gauge and must fit inside of gauge with the ends of the spring wires perpendicular to the plate ). Once inserted in the plate gauge take the .250” no-go gage and check the center coil spacing on both sides. The .250” no-go gauge must be parallel to the spring wire and perpendicular to the center of the spring when checking. The .250” no-go must pass check on at least one side of the spring. This check is to be performed after the 10.8/lb check and .071 max wire diameter check have been performed.

Important Note

Due to distribution issues and availability the Mandantory date of 7/1/2012 for the BSFW-1 (Steel Flywheel) will be suspended until these circumstances have been resolved. Also with the no timing rule for the BS classes there should be negligible performance variations between the BSFW-1 and the current Stock cast flywheel.

info @ www.americankartracingassociation.com

AND.......More flywheel notes.

_________________
"It's not in my nature to spend money sparingly when I'm having a good time"


Wed Mar 14, 2012 6:50 pm
Profile
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron