It is currently Tue Nov 24, 2020 9:06 am




Post new topic Reply to topic  [ 1 post ] 
 Clone Zone..Tech Update 
Vice President

Joined: Sat Feb 28, 2009 11:19 pm
Posts: 539
Location: Columbus, Ohio
Class: Jr. Clone
Chassis: Bandit
Engine: 4 cycle Clone
Post Clone Zone..Tech Update
AKRA has added a couple new rules to the Clone Box Stock Class for 2013.

1) Sealer is now allowed on the head gasket.

2) Carb Insulator. Hole in insulator may be de-burred for the purpose of removing flashing ONLY. Re-sizing, or intentional directing of air/fuel mixture into port is illegal.

3)Valve Springs.PAY ATTENTION TO THIS ONE.
Measured in the following order: Max wire diameter is .071
Installed height is .815
10.8 lbs. @ .850
18 lbs. max. @ .650 *THIS DOES NOT MEAN YOU CAN RUN 18 lb. SPRINGS. IT MEANS THE SPRING CANNOT BE OVER 18 lbs. @ .650
Coil spacing is still the same at .250 using approved gauge.
If valve seal is used, the rubber must be present and whole.

_________________
"It's not in my nature to spend money sparingly when I'm having a good time"


Mon Mar 25, 2013 6:56 pm
Profile
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron